Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Sascha Franck

Pages: [1]
1
When you activate the PA in an empty (default) preset, the volume will be at 0. But there's a massive volume bump.
When you then adjust the volume, things are fine.
But once you save, leave the preset and recall it, the volume will be WAY up again, so everything distorts.

As is, the PA feature is completely unusable. Needs to be fixed.

2
Hi folks,

Thought I could share this with you.

Instead of using the Pangea as a plain IR loader, I bought it to replace whatever "full" amps. Of course I am aware that there's no dynamics captured in an IR, so any kind of amp overdrive and/or compression would not be available. But then, over the last few years, all my sounds were coming from my pedalboard only, so all I really need is a clean, pedalfriendly amp. Which is what I have been using for around the last 5 years or so (amps used: clean channel of either a Boogie MKIV, a Fender "The Twin" or a Laney LC50).
To get similarily good results from IRs only, I have been creating individual IRs from some pre- and poweramps and then run them through whatever cab IRs. I tried all that out inside Logic, which would allow me to run IRs serially, parallely, EQ them, stack them up and so on. Once I was happy with a certain setup I mixed everything down to single IRs which I am now loading into the Pangea.
And guess what? This is working amazingly well! I have already played 2 gigs with just my pedalboard and the Pangea, one via InEar, the other using a rather nice RCF FR monitor. Kickass sound and I didn't miss my amps for a single minute.
I may add some compressor in the future, but for now this seems to be the way to go for me.

I could happily post a soundfile or one or the other IRs I'm using.

Cheers
Sascha

Pages: [1]