Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - ccouch7

Pages: [1]
1
I've looked all over AMT's website trying to find information on
what is in the latest firmware update for the CP-100, with no luck.
Does anybody know what it adds or changes?

Would it kill AMT to provide this info in an easy to find way???

First the messed up Windows Editor installation process with an .info file-
(which I refuse to do).
And now no info on anything regarding the newest firmware that I can find,
even in the "Readme" file in the download!

I really like this little box, but I could not honestly recommend it to anyone.
It's as if AMT do not want to sell any of these and are trying to make it
hard for people to like or understand. 

2
Is anyone else having problems getting the new PC editor to work?

I updated the firmware to 2.5.5 and that went ok.

But when I followed the instructions to install the Editor it seemed
like the drivers (amt.inf ?) it needed to work were not included in the download.
________________________________________
The application’s installation instructions:

1. Download the archive file CP100Setup.zip.
2. Unzip the file.
3. Connect the CP-100 to a PC with an USB cable and choose the CP-100 mode – USB Drive
4. Copy in the USB drive root folder the file – firmware (it is in the unzipped folder).
5. Safely unmount USB-drive and disconnect the USB cable.
6. Connect a power adapter to the CP100.
7. After the program is renewed, connect the USB cable and chose CP-100 mode “Serial port”.
8. Install CP-100 USB virtual serial port drivers – amt.inf (the file is in the unzipped archive folder).
9. Run the file CP100Setup.exe to install the application.
10. On the end of the installation, run the application AMT Pangaea CP_100
.
____________________________________________________________________

Any help much appreciated.

3
With my Pangaea I've been using only 3Sigma Audio IR's. They are really consistent
volume wise from IR to IR.
However, I need to lower the volume of the Pangaea's output across all of them by
the same amount.
Is there an easier way to do this than going in and lowering each volume of each
preset separately 100 times on the Pangaea!!??

Thanks for any help.

Pages: [1]